Trade Show Sampling for gemstone Jewelry
A trade show converts on the sample that leaves the booth, not on the catalogue that gets left behind. The sample card has to carry the model number, the metal, the stone size, the FOB price and the MOQ, or the follow-up email starts from zero, shipped as display tray with sample card and certified GRA report.
Ten to twelve pieces on a tray is the useful number for gemstone Jewelry. More than that and the buyer photographs instead of touching, and a photograph is not an order, on a 100-piece Trade Show Sample order at USD 3-104.
The follow-up window is seven days. After that the card sits in a stack. We write the quote the same week and put the sample in the post so the buyer has the piece on the desk when the price arrives, shipped as display tray with sample card and certified GRA report.
The Reject Tray Policy That Decides a Partnership
Last July, a US buyer of gemstone Jewelry placed 100 gemstone Jewelry against a sample signed in November. The first container landed with 9 pieces that failed on sieve drift alone, and USD 5-30 landed on the buyer's P&L before a single unit sold, which is USD 3-104 on the Trade Show Sample schedule.
On a 100-piece order at USD 3-104, a sieve drift rate above two percent is not a quality surprise. It is a costing error that shows up as a credit note three weeks later.
Nothing in the rebuild was expensive. A gauge, a written limit and a retained tray did the work that a discount would only have delayed, which the Trade Show Sample file records at USD 3-104 in display tray with sample card.
What US buyers Check Before They Sign
At USD 3-104 per piece the four measurements below are worth more than the discount being negotiated. One of them costs nothing to write down.
| Spec point | Common trade output | HOLYCOME standard | Cost if missed |
|---|---|---|---|
| Stone colour consistency | Graded by eye under D65 | Colour matched to a retained master stone, per tray | Repeat colour complaint in the same SKU |
| Sizing drift across the run | Not measured | Go/no-go gauge on every size, drift held under 0.15 mm | Resize queue and reship cost |
| Clasp spring life | Sampled by hand | Cycled 500 times on a jig per lot | Detach claim and brand damage |
| Prong tension and seat depth | Checked by feel at the bench | Pull-tested per piece, seat depth written on the sheet | Stone loss and total replacement |
Write these into the Trade Show Sample purchase order and the arrival check becomes arithmetic instead of recollection, the figure being USD 3-104 for a 100-piece run.
Where USD 3-104 Per Piece Actually Goes
Cost at USD 3-104 leaves no room for assumption. The table shows which line compresses and which line only moves quality down.
| Cost line | Share | What moves it |
|---|---|---|
| Base metal or alloy for gemstone Jewelry | 30% | Alloy choice and casting yield |
| Stone or melee for gemstone Jewelry | 20% | Sieve range and lot batching |
| Setting and finishing labor for gemstone Jewelry | 19% | Jig design and bench minutes |
| Plating, polish and QC for gemstone Jewelry | 12% | Per-tray versus per-piece checks |
| Packaging for gemstone Jewelry | 19% | display tray with sample card |
A factory that cannot state its bench minutes per piece has never costed its own line. Ask for minutes and for the reject rule, not for a discount, shipped as display tray with sample card and certified GRA report, certified GRA report and packed display tray with sample card at 100 pieces.
The Reject Tray Policy That Decides a Partnership
On gemstone Jewelry, the cheapest answer is rarely the cheapest outcome once the second season is counted, on a 100-piece Trade Show Sample order at USD 3-104.
The commercial version of this question for gemstone Jewelry is simple: what does a failure cost the buyer, and who pays it. In our terms the answer is a replacement inside the same order cycle, with the retained reference tray as the arbiter, quoted at USD 3-104 per piece in display tray with sample card.
That clause matters more than a discount on gemstone Jewelry. A 4% lower unit price disappears on the first rejected tray; a written responsibility clause does not, and the Trade Show Sample quote for it sits at USD 3-104.
What the Quote Actually Covers
A buyer who understands this about gemstone Jewelry negotiates differently, and usually negotiates less, on a 100-piece Trade Show Sample order at USD 3-104.
What buyers underestimate on gemstone Jewelry is the cost of the interruption, not the cost of the piece. A missing 6% of a run stalls a launch, and a stalled launch costs more than the 6% ever did, and 100 pieces leaves Wuzhou in display tray with sample card at USD 3-104.
We plan a 3-5% buffer on first runs of gemstone Jewelry and tell the buyer it exists. Hiding a buffer and shipping it as production is how a supplier trains a buyer to distrust the count, the figure being USD 3-104 for a 100-piece run.
Order Terms, Sample Timing and Packing
The commercial frame is short enough to state in full. Minimum order is 50 pieces per design, and mixed designs travel in one shipment, so a 100-piece Trade Show Sample order can carry three or four models without a separate setup charge. Sample pieces leave in 3-5 days when the components are in stock, and a new model adds about twenty days before the first article exists, which is how the Trade Show Sample account reads it at USD 3-104.
Payment is 30 percent with the order and 70 percent against the bill of lading, with the balance window stated on the invoice rather than agreed by message. Prices quoted at USD 3-104 are FOB Guangzhou or Shenzhen; DDP is quoted separately because the duty line moves with the tariff schedule and not with our cost.
Packing follows the display tray with sample card format at 100 pieces to the carton, and the packing list carries SKU, size and stone size so receiving can count without opening every box. Private-label cartons add three days for the print run and must be approved before the first bulk order, not after it, which is USD 3-104 on the Trade Show Sample schedule.
Certification is GRA report for the lots that carry it, with a batch report and per-piece measurement of size distribution within the declared sieve for the lots below the threshold. The document set travels with the shipping papers, which is what a customs broker asks for at the port rather than after clearance, on a 100-piece Trade Show Sample order at USD 3-104.
A rejected tray is settled inside the same order cycle against the retained reference piece. If the difference sits on our retained sample we replace or credit; if it appeared in transit we split the assay cost and file with the carrier, and that rule is written on the order before the deposit clears, and the Trade Show Sample quote for it sits at USD 3-104.
The Three Failures We See Most in Incoming Samples
mixed color lots
Mixing near-colorless and G-H stones in one parcel produces a finished piece with a visible tonal step. Parcels ship by single lot, on a 100-piece Trade Show Sample order at USD 3-104.
Our countermeasure is a gauge and a written limit. It adds about 6 seconds per piece and removes the defect from the run rather than from the carton, which the Trade Show Sample file records at USD 3-104 in display tray with sample card.
girdle damage
Stones packed loose in a bag chip each other in transit. Individually wrapped parcels cost more and arrive usable, certified GRA report and packed display tray with sample card at 100 pieces.
In a 100-piece run this typically shows on 17 of pieces. Catching it means measuring size distribution within the declared sieve at the tray level, not inspecting the finished carton, priced at USD 3-104 for the 100-piece Trade Show Sample run.
sieve drift
A parcel sold as 2.0-2.2 mm with 15% of stones at 1.9 mm changes the setting labor on the buyer's bench. Sieve the parcel, do not sample it, which is USD 3-104 on the Trade Show Sample schedule.
The commercial effect is replacement stones plus a sorting delay on the buyer's line. Buyers who have seen it once put it in the purchase order; buyers who have not usually discover it on the first return, on a 100-piece Trade Show Sample order at USD 3-104.
What This Means for a First Order
A first Trade Show Sample order of 50 pieces per design at USD 3-104 tests the line rather than the range. Three designs covers the shelf.
Ask for the retained tray and the GRA report batch sheet with the first shipment. Both are free and both decide the reorder, and 100 pieces leaves Wuzhou in display tray with sample card at USD 3-104.
How a Repeat Order Gets Built
Nothing in this sequence is unusual, and that is the point. Each step exists because skipping it produced a specific failure on a previous order, and at USD 3-104 for 100 pieces that is the number the buyer signs.
- Lock the spec: metal, stone size range, plating thickness, sizing band and finish, all written on one sheet.
- Pull a stock-component sample in 3-5 days and measure it against that sheet, not against the photo.
- Approve the sample in writing, including the reject rule and the retained reference tray.
- Run bulk in 15-20 days for orders under 500 pieces, with the gauge check independent of the shift.
- Ship from Guangzhou or Shenzhen with the QC sheet in the carton and the batch report by email.
Reorders inside this sequence run 12-15 days because the model, the gauge set and the signed spec stay in our system, which is USD 3-104 on the Trade Show Sample schedule.
Freight, Duty and the Arrival Check
Export runs through Guangzhou or Shenzhen. Air lands in 5-8 days on the US west coast, 7-10 on the east, and sea takes roughly three times the transit, on a 100-piece Trade Show Sample order at USD 3-104.
FOB is the default on gemstone Jewelry and DDP is the option. Buyers new to the American bridal market usually take DDP once, then switch after they see the breakdown, with GRA report and display tray with sample card stated on the same sheet, certified GRA report and packed display tray with sample card at 100 pieces.
If sieve drift appears in the arrival check, the retained tray decides who owns it. Keep the GRA report batch sheet in the same folder as the packing list, quoted at USD 3-104 per piece in display tray with sample card.
Frequently Asked Questions
How do you handle a rejected tray?
We replace or credit inside the same order cycle. The retained reference tray decides: if sieve drift shows on our retained piece we own it, and if it appeared in transit we split the assay cost and file with the carrier, the figure being USD 3-104 for a 100-piece run.
What are the payment terms?
30 percent deposit with the order, 70 percent against the bill of lading. For accounts on a second order we quote 30/70 with a 15-day balance window once the first shipment has cleared, which is how the Trade Show Sample account reads it at USD 3-104.
What is the minimum order for gemstone Jewelry?
50 pieces per gemstone Jewelry. Designs mix inside one shipment, so a first order of three designs at 50 pieces each is normal for a new US account. Below 50 the gauge check stops being independent of the shift, which the Trade Show Sample file records at USD 3-104 in display tray with sample card.
Do you supply certificates for gemstone Jewelry?
GRA report on gemstone Jewelry above the threshold stated on the quote. Below it we supply a batch report plus per-piece measurement of size distribution within the declared sieve, which is what a counter or a listing actually needs, and at USD 3-104 for 100 pieces that is the number the buyer signs.
How do you handle a rejected tray?
We replace or credit inside the same order cycle. The retained reference tray decides: if sieve drift shows on our retained piece we own it, and if it appeared in transit we split the assay cost and file with the carrier, the figure being USD 3-104 for a 100-piece run.
Next Step
The next step is a sample in 3-5 days, not a container. Write to service@holycome.com or WhatsApp +86 18078079070, subject Trade Show Sample, with GRA report and display tray with sample card stated on the same sheet.
HOLYCOME is operated by Wuzhou HengliLai Jewelry Co., Ltd., a factory in Wuzhou, Guangxi, producing since 2009 at roughly 60,000 pieces a month. Contact service@holycome.com or WhatsApp +86 18078079070, quoted at USD 3-104 per piece in display tray with sample card.
Related reading: Gemstone Jewelry Q4 Holiday Stock: What the Quote Actually Covers - HOLYCOME 18K Gold Rings Bridal Boutique: The Sample Approval That Survives Production - HOLYCOME




